Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - traindriver69

Pages: [1] 2 3
1
HARDWARE/SYSTEMS DISCUSSION / Oric 1 power supply output
« on: December 11, 2018, 05:43:14 PM »
Hi all
I have just purchased a oric 1 computer but when I plug it in I get a multicoloured screen for a few seconds then it boots up to the normal screen then sometimes it locks up so have to power off and on again to get it to work again then while testing the keyboard sometimes I get a coloured line across some of the text so the first thing I have done is test the power supply which is the correct oric one but it says 9v output but when I test it with a multimeter it is outputting 12v is this correct if it is then I can start investigating further.
Many thanks

2
HARDWARE/SYSTEMS DISCUSSION / BBC B computer help please
« on: October 31, 2018, 06:18:39 PM »
Hi all
I Have just picked up a BBC computer and plugged it in and just get a continuous beep with two lights lit and no picture.
So I opened it up to investigate further but a little unsure which version I have on the motherboard it says
0233,000 ISS 1 copyright 1984 and on the bottom case instead of a normal Acorn number it says
Cleartone Abercarn Gwent 105099.
Many thanks in advance

3
HARDWARE/SYSTEMS DISCUSSION / mattel aquarius memory help
« on: November 01, 2015, 03:22:23 PM »
hi all
I have a mattel aquarius home computer and recently purchased a 16k ram pack for it but I dont think it is working.
I have tried to load a game and get OM Error which I take to mean out of memory error.
does anyone know if there is anything I can type in to the computer to see how much memory is there.
many thanks in advance.

4
HARDWARE/SYSTEMS DISCUSSION / acorn electron gone faulty
« on: February 02, 2015, 12:37:10 PM »
hi all
got my old acorn electron out and it has developed a fault when it has been left switched on for a couple of minutes lines start going across the screen and the computer locks up then when you disconnect the power and turn it back on you get a yellow screen and there is no clicking noise which you normally get when you turn it on but if you disconnect the power there is a clicking noise.
if you leave it powered off for a couple of mins the acorn comes back to life but then it all starts again.
anyone got any ideas please.

5
HARDWARE/SYSTEMS DISCUSSION / Re: atari 400 power supply question
« on: November 26, 2014, 04:41:27 PM »
I just dont understand why the wires for the mains plug are not color coded unless there is someone out there who has one and can lok in the plug the part number is C017945 its a 9v ac 31 VA

6
HARDWARE/SYSTEMS DISCUSSION / atari 400 power supply question
« on: November 26, 2014, 03:20:10 PM »
Hi all
I have a boxed atari 400 on its way but has no power supply with it but in my collection I have one my problem is at the moment there is no plug on it and the two wires are not color coded so I am not sure which wire goes where in the plug or does it mater.
many thanks in advance

7
FOR SALE / WANTED / Commodore 64 Bread bin style
« on: May 08, 2013, 06:35:03 PM »
hi all
I am after a working Commodore 64 Bread bin style computer boxed would be nice but not essential.
many thanks in advance

8
FOR SALE / WANTED / wanted amiga 1200 4mb trapdoor card
« on: June 09, 2012, 06:32:46 PM »
hi all
I am after a memory card for my amiga 1200 i would like at least a 4mb so that i can run whdload without any problems.
many thanks

9
FOR SALE / WANTED / wanted nintendo nes boxed if possible
« on: February 13, 2012, 07:10:21 PM »
Hi all
I am after a nintendo nes boxed if possible just so i can play mario would like it boxed if possible as that is how i like collecting my retro computer stuff but will take without and if you have mario game cart to go with it even better.
many thanks in advance.

10
FOR SALE / WANTED / SEGA ARCADE POWER STICK II SIX BUTTON
« on: January 05, 2012, 05:07:16 PM »
Hi all
If anyone is intrested I have a SEGA ARCADE POWER STICK II SIX BUTTON controller for sale not sure what it is worth.
many thanks

11
HARDWARE/SYSTEMS DISCUSSION / Re: atari atx to atr help
« on: October 10, 2011, 07:07:16 PM »
dont worry you are not teaching me to suck eggs problem is i am a collector of retro computers a couple of weeks ago i was playing my bbc at the moment i am on the atari next month could be a commodore or sinclair so i forget things what does holding down the option key do.
many thanks

12
HARDWARE/SYSTEMS DISCUSSION / Re: atari atx to atr help
« on: October 10, 2011, 06:30:45 PM »
the discs seem fine they are single sided single density some of the games work fine but others either start to load or get nowhere the settings are set at default as it is the unregestered version of ape

13
HARDWARE/SYSTEMS DISCUSSION / Re: atari atx to atr help
« on: October 05, 2011, 08:54:53 PM »
hi yes i am using ape tried the link for the website but the couple i have downloaded so far have not worked on my atari

14
HARDWARE/SYSTEMS DISCUSSION / atari atx to atr help
« on: October 05, 2011, 07:11:10 PM »
hi all
I have just got my sio2pc interface from atarimax and want to put some games from the internet onto my 1050 drive to play on my atari 800xl.
only problem is with the software i have with it only .atr files are reconized but alot of the games are .atx is there a way of converting them to .atr or is there some other software out there that can handle them.
many thanks in advance

15
thanks for the reply
found the .cas files now and turned them into wav with out using any of the settings but not had any look getting a game to load.
is there any settings that i should enter in cas2wav to get them to load.
many thanks

Pages: [1] 2 3